Good morning all,
I have been tasked with translating an old s5 to something more modern i have only a printed version of the program in STL and ladder but i have a section of STL which has no ladder equivalent and not sure how it should be drawn.
The STL looks like this as one segment
:A I0.5
:AN F1.6
:= F1.7
:A I0.5
:= F1.6
So i have AND I0.5 ANDNOT F1.6 to coil F1.7
then AND I0.5 to coil F1.6
is this just drawn as two separate lines?
Sorry if this is a simple question just not programmed with siemens before
Regards
Matt